If you are converting your garage to living space and plan to install a new floor, it is usually smart to begin by insulating the concrete floor. You might also choose to insulate a garage floor if you plan to use the garage as a workshop, or even if you are still storing vehicles in it. An insulated floor can make a garage much more comfortable to work in during cold weather, and it can make a garage conversion much more pleasant to live in.
There are two ways to handle insulating concrete floors. You can attach wood sleepers to the floor, fill the gaps with rigid-foam insulation, and then apply a subfloor and finish flooring. Or, as demonstrated here, you can cover the slab with rigid-foam insulation, add two layers of plywood, and then add the finish flooring.
Before You Begin
Any time a flooring material is laid over concrete, it is important to control moisture bleeding through the concrete. Although it looks like solid rock, concrete is actually fairly porous, and ground moisture easily migrates through the slab to affect any surface material laid over the concrete. It’s especially important to control moisture in indoor locations to avoid damage to surface flooring materials, but it’s important to control moisture even if the garage will continue to be a vehicle-storage space. Moisture very often becomes an issue, even if the slab appears to be dry.
In our project, controlling moisture in the slab is done by using exterior-grade plywood sheets laid over the foam insulating panels, and also by laying down a sheet of polyethylene plastic as a vapor barrier to block moisture. When a slab is being insulated in new construction, the vapor barrier is usually laid down first, before the slab is poured. But when adding insulation to an existing slab, the vapor barrier is laid over the top of the slab before the foam insulating panels are installed.
For the foam insulating layer, be sure to use compression-grade rigid foam panels, which are designed for installation beneath concrete slabs and will bear up under the weight if the new floor will continue to support vehicles. Check with your supplier or the manufacturer for advice on the best thickness and R-value to use. Some insulating panels come with attached vapor barriers. With this type of panel, no plastic sheeting is required since the panels themselves provide a sufficient vapor barrier once the seams are sealed with impermeable tape.
Handling the Thresholds
A layer of foam insulation and two layers of plywood can add as much as 2 inches of height to the garage floor. This can be a problem if the garage will continue to be used to store vehicles since it leaves you with a substantially raised lip at the doorway to the garage. Various edging strips or thresholds are available to help smooth this transition. Check with manufacturers of garage flooring tiles for transition thresholds that fit the height of your insulated garage floor.
You may face a similar problem at the threshold of the passage door to the garage, where it may be necessary to install a different threshold and perhaps even shorten the door to accommodate the new height of the floor.
Some garage floors are subject to frequent moisture and puddling and may even have floor drains to help remove moisture that enters the garage. In addition, some older homes have basement drive-under garages, for example, where dampness or puddling may be a fact of life. Laying foam insulating panels and a new subfloor over such a concrete slab can be problematic, since water will be trapped beneath the floor, encouraging rot and mold.
In garages where moisture is an ongoing issue, it’s best to consult a building engineer before covering the floor and converting the garage to living space. Adapted construction techniques or a special drainage system, such as perimeter drain tile and a sump pump, may be necessary to ensure that the garage floor remains dry enough to maintain a safe, healthy living space.
Disclaimer: Curated and re-published here. We do not claim anything as we translated and re-published using google translator. All images and Tattoo Design ideas shared only for information purpose.